Troubleshooting
71
Problem Possible Cause Possible Solution
Optical Drive Problems
The Media Player
Access indicator
on the Status
Indicator Panel
blinks at regular
intervals when no
disc is in the tray
or the media drive
is not installed.
The notebook fails
to Auto-Play a
DVD movie.
The media player
will not play
international DVD
titles
The Windows media
player auto insert
notification function is
active and is checking to
see if a media disc is
ready to run.
The media player software
has not been installed.
The region code for the
DVD does not match that
of the media player.
This is normal.
Locate and install the DVD-ROM Applications
CD.
All Fujitsu notebook DVD drive is pre-set at
factory to read DVD title with region codes for
specific Asia Pacific markets (e.g. code 3 for
Asian, code 4 for Australia, code 6 for China).
The first time you play a DVD title with a
region code different from that of the DVD
optical drive - the region code set at factory,
you will be prompted to change the region
code of the DVD optical drive. The region code
of a DVD optical drive can be changed up to 4
times, after which it will be locked so that the
DVD optical drive can only play DVD titles of
the final region code set.
Hard Drive Problems
You cannot access
your hard drive.
The setup utility is
incorrectly set for your
internal (Primary Master)
or optional second hard
drive (Primary Slave).
The wrong drive
designator was used by
an application when a
bootable CD-ROM was
used to start the LifeBook
notebook.
Revise BIOS settings to set both Primary
Master and Primary Slave correctly.
Verify drive designator used by application is
in use by the operating system. When the
operating system is booted from a CD, drive
designations are automatically adjusted.
LB_Topaz 06 (67-80) 11/10/05, 8:34 AM71
To Next Page
Loading...
