64
Problem Possible Cause Possible Solution
Video Problems
Display is blank
when you turn on
the system.
When the ATI
Driver CD is first
installed, you
receive a Microsoft
message informing
you that the ATI
driver is not
compatible with
your operating
system.
The LifeBook
notebook turned
on with a series of
beeps and your
built-in display is
blank.
Something is pushing on
the Closed Cover switch.
The LifeBook notebook is
set for an external monitor
only.
The angle and brightness
settings of the display are
not adequate for the
lighting conditions.
The power management
timeouts may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
The warning does not
apply to your LifeBook; the
driver has been
thoroughly tested and its
installation will not
jeopardize the
performance of your
system.
Power On Self Test
(POST) has detected a
failure which does not
allow the display to
operate.
Clear the Closed Cover switch.
Pressing [F10] while holding down the [Fn] key
allows you to change the destination of your
display video. Each time you press the
combination of keys you will step to the next
choice. The choices, in order, are: built-in
display only, external monitor only, both built-in
display and external monitor.
Move the display and the brightness control
until you have adequate visibility.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Power/Suspend/Resume button.
(The display may be shut off by Standy mode,
Auto Suspend or Video Timeout)
If this message appears on your screen, click
the Continue Anyway or Yes buttons to
proceed.
Contact your support representative.
LB_Topaz 06 (53-66) 2/3/05, 2:28 PM64
To Next Page
Loading...
