Working with the notebook
LCD screen
Background lighting
LCD screens are operated with background lighting. The luminosity of the background
lighting can decrease during the period of use of the notebook. However, you can
set the brightness of your monitor individually.
Synchronizing the display on the LCD screen and an external monitor
For more information, please refer to Chapter "Key combinations", Page 43
under "Switching between display outputs".
Ambient light sensor
If your notebook was shipped with a Windows operating system, the screen brightness is
regulated by the ambient light sensor and is dependent on the particular light conditions.
This results in optimum readability and longer battery life at the same time.
Using the device as a Tablet PC
You can execute commands as follows:
•
using the stylus (supplied with your device).
•
using your finger
Using your fingers
You can execute certain commands by using your finger tip on the touchscreen of your device.
Alternatively, everything which you can select or activate using your finger
tip can also be selected or activated using the stylus.
Calibrating the Dual Digitizer for finger-based operation of the device
Please see chapter "Calibrating the stylus", Page 36 for instructions on how
to calibrate your device to use Dual Digitizer Technology.
Please note: There are separate calibration programs available for calibrating
the stylus and for calibrating finger-based operation. Do not use the calibration
tool for the stylus to calibrate finger-based operation.
To Next Page
Loading...
