Error messages on the screen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service center.
User and/or supervisor SmartCard lost
User and/or supervisor SmartCard lost
► If you have lost your user SmartCard, you
can continue to work with the supervisor
SmartCard.
► If you have lost the supervisor SmartCard,
you can also continue working, but y
ou no
l
onger have all rights and cannot initializ
e
anot
her supervisor SmartCard.
A beep sounds every few seconds.
The battery is almost dead.
If the error message occurs repeatedly, the
back-up battery in the notebook is dead.
Contact your sales outlet or our customer
service center.
System CMOS checksum bad - Default configuration
The system configuration information is
incorrect.
Press the function key
F2
to access the
BIOS Setup.
In the BIOS Setup, select the Exit menu.
Select the entry Load Setup Defaults.
Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
Check whether the additional memory
module has been inserted correctly.
The settings of the hard disk drive are incorrect.
Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
To Next Page
Loading...
