Removing and installing components during servicing
Preparing to remove components
If you are going to remove or change system components, prepare for the removal as follows:
Please observe the safety information in chapter "Important notes", Page 13.
Remove the AC plug from the power outlet!
► Switch the device off.
The device must not be in energy saving mode.
► Close the LCD screen.
► Remove all the cables from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► Remove the battery, see
"Removing a battery", Page 47.
To Next Page
Loading...
