Working with the notebook
Connecting the mains adapter to the Port Replicator
1
2
3
► Connect the mains adapter cable to the DC
jack (D C IN) of the Port Replicator (1).
► Connect the power cable to the
mains adapter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Re plicator, the operating syste m creates
a hardware profile f or the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This p rofile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on t he noteboo k via the port replicator
► Press the ON /O
FF switch on the port
replicator to
switch the noteb ook on.
The power-on indicator of the Port
Replicator lights up.
Switchi
ng off noteboo k via Port Replicato r
► Close all applications and shut down your operating system (please refer
to the manual for the operating s ystem).
If the notebook cannot be shut down properly, pre ss the ON/OFF button
on the Po rt Replicator for approx. four seconds. The notebook will switch
off. Any unsaved data may however be lost.
Fujitsu Technology Solutions 51
To Next Page
Loading...
