Security functions
Activating system protection
► Start the BIOS Setup Utilit y and go to the Security menu.
Operatings ystem
► Select the Password on Bo ot option and press the Enter key.
► Select the desired option (Disabled, First Boot or Every Boot) and press the Enter key
► Select the Save Changes & Exit option under Exit.
The note book will reboot. You will be prompted to enter your password (the supervisor password).
Deactivating system protection
► Start the BIOS Setup Utilit y and go to the Security menu.
Operatings ystem
► Select the Password on Bo ot option and press the Enter key.
► Select the Disabled option and press the Ent er key.
If you do not want to change any other settings, you can exit BIOS Setup Utility.
► Select the Save Changes & Exit option under Exit.
The notebook will reboot. The system is n o longer passw ord-prote cted .
Password protection for the hard disk
Passwordpr otec
tion:
The had disk password prevents unaut horised access to the hard disk drives
and is checked internally each time the system is booted. The condition for this
is that you have assigned at least the supervisor password.
Activating hard disk protection
► Call up the BIO
SSetupand select the Security menu.
If you have not assigned BIOS passwords yet, define the supervisor and the user
password now, if desired (see "
Secu rity functions " , Page 53).
► Mark the Har
d D isk Security field and press the Enter key.
► In the Drive 0 are a ma rk the Set Master Password field and press the Enter key.
Enter new P
assword then appears and you are asked to enter a password.
► Enter the password and press the Enter key.
Confirm ne
w Password requires you to confirm the password.
► Enter the password again and press the Enter key.
Setup Not
ice: Changes h ave been saved is displayed to confirm that the
new pass
word has been saved .
► To assign the password for the second hard disk ( Drive1 ), go to the Drive1 area and
select the field Set Master Password, then proceed in exactly the same way as for
setting up the password for the first hard disk (Drive0 ).
The fie
ld Password Entry on Boot is set to Enabled by default. You can exit the BIOS
Setup
once you have finished changing the settings.
► From the Exit menu, choose the option Exit Saving Changes.
► Pres
s the Enter key and select Yes.
The notebook reboots and your hard disk is now protected with a password. The system
will ask y ou to enter the password when the notebook is restarted again.
56 Fujitsu Technology Solutions
To Next Page
Loading...
