Manufacturer’s notes
Regulatory notices
If the re is no FCC logo and also no FCC ID on the device then this device is
not approved by the Federal Communications Commission (FCC) of the USA.
Although it is not explicitly forbidden to travel in the US trading area carrying this
device, to avoid trouble at customs clearance, Fujitsu Technology Solutions GmbH
recommends not to bring this device into the US trading area.
Regulatory info rmation f
or notebooks without radio device
Regulatoryinf ormation
NOTICE:
Changes or modifications not expressly approved by F ujitsu Technology Solutions
could void this user’s authority to operate the e quip ment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. Th is equipment generates, uses, and can radiate r adio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio comm unications. However, there is no g u a rantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the sep
aration between the equipment and receiver.
• Connect th e equipment into an outlet that is on a different circuit than the receiver.
• Consult the dea
ler or an expe rienced radio/TV technician for help.
Notice to Users of the US Telephone N etwork
Your notebook may be supplied with an internal modem w hich complies with P art 68 of the
FCC rules. O n this notebook is a label that contains the FCC Registration Nu mber an d the
Ringer Equivalence Number (REN) for this equipment amo ng other information. If requested,
the user must provide their telephone company with the following information:
1. The telephone number to which the notebook is connected.
2. The Ringer
Equivalence Numbe r (REN) for this equipment.
3. The equipment requires a standard modular jack type USOC RJ-11 C
which is FCC Part 68 compliant.
4. The FCC Re
gistration Number.
This equipment is designed to be connected to the telephone network or premises wiring using
a standard m odular jack type USOC RJ-11C which is FCC Part 68 compliant and a line cord
between the modem and the telephone network with a minimum of 26AWG.
The REN is used to determine the number of devices that you may connect to your telephone
line and still have all of those devices ring when your number is called. Too many devices
on one line m ay result in failure to ring in response to an incoming c all. In most, b ut not all,
areas the sum of the RENs of all of the devices should not exceed five (5). To be certain
of the numbe r of devices you may connect to your line, as determined by the RENs, contact
your lo cal telephone company. If this equipment causes harm to the telephone network, your
telephone company may disco ntinue your service tem porarily. If possible, they will notify you
in advance. If advance notice is not practical they will notify you as soon as possible. You
will also be advised of your right to file a complaint with the FCC.
88 Fujitsu Technology Solutions
To Next Page
Loading...
