66
- Starting Your LifeBook Tablet PC
Starting Your LifeBook Tablet PC
Power On
Power/Suspend/Resume Button
The Power/Suspend/Resume button is used to turn on your LifeBook Tablet PC from its off state. Once
you have connected your AC adapter or charged the internal Lithium ion battery, you can power on your
LifeBook Tablet PC.
To turn on your LifeBook Tablet PC from its off state, slide the Power/Suspend/Resume switch sideways.
It is located above the keyboard to the right. When you are done working you can either leave your Tablet
PC in Suspend mode, See “Sleep Mode” on page 72 or you can turn it off. See “Powering Off” on page 75.
When you power on your LifeBook, it will perform a Power On Self Test (POST) to check the internal
parts and configuration for correct functionality. If a fault is found, your LifeBook Tablet PC will emit an
audio warning and/or an error message will be displayed. See “Power On Self Test Messages” on
page 108. Depending on the nature of the problem, you may be able to continue by starting the operating
system or by entering the BIOS setup utility and revising the settings.
After satisfactory completion of the POST, your Tablet PC will load your operating system.
WHEN YOU TURN ON YOUR LIFEBOOK TABLET PC BE SURE YOU HAVE A POWER SOURCE. THIS MEANS
THAT AT LEAST ONE BATTERY IS INSTALLED AND CHARGED, OR THAT THE AC OR AUTO/AIRLINE
ADAPTER IS CONNECTED AND HAS POWER.
D
O NOT CARRY YOUR LIFEBOOK TABLET PC AROUND WITH THE POWER ON OR SUBJECT IT TO SHOCKS
OR VIBRATION, AS YOU RISK DAMAGING YOUR TABLET PC.
To Next Page
Loading...
