Troubleshooting and tips
The external monitor remains bl
ank
Monitor
Cause Troub leshooting
Monitor is sw itched off. ► Switch the external mon itor on.
Power saving has been activated (monitor is
blank).
► Press any key to continue.
Brightness is set to dark.
► Adjust the brightness of the
monitor.
Screen output is set to the notebook’s LCD
screen
► Press the key combination
to switch the
screen output, see "
Key c
ombina tions",
Page 42.
The external monitor’s
power cable or data
cable is not connected p
roperly.
► Switch off the external monitor and the
notebook.
► Check whether the power cab le is plugged
properly into the external monitor and into
the power socket.
► Check whether the data cab le is properly
connected to the notebook and the external
monitor (if it is plugged in with a connector).
► Switch on the external monitor and the
notebook.
The external monitor is blank or the image is unstable
ScreenMonitor
Cause Troub leshooting
The wrong external monitor has been selected
or the w rong screen resolution ha s been set for
the application program.
► Terminate the application program in
Windows by pressing
Alt
+
F4
.Ifthe
fault persists after closing the program, use
the key combination for switching the screen
output (see "
Key combinations", Page 42)to
switch over to the notebook’s LCD screen.
Change the following setting:
► Set the screen resolution: Set th e screen
resolution as described in the documentation
for your operating system.
► Select monitor: Select monitor 1 or 2 as
described in the documentation for your
operating system.
Fujitsu 101
To Next Page
Loading...
