Security functions
New SmartCards h ave a preset PUK (see above).
if you want to re-initialise a previously initialised SmartC ard, you will need
to know the PUK whic h was assigned to it.
► Enter the PUK.
When the following appears:
• ACCESS DENIED = You ha ve entered a n invalid PUK. After six faile d attempts,
the Sm artCard will be blocked and can no longer be used.
► Enter a new PIN at the following prompt:
Enter new PIN:
Confirm new PIN:
A number with 4 to 8 digits is acceptable for the new PUK. For security
reasons, we recommend that you change the PUK for every SmartCard,
and use an 8-digit number each time.
► Re-enter the new PIN to con firm.
When the following
appears:
• PIN/PUK do not match = You have confirmed the PIN incorrectly. You will be
requested to re-enter the new PIN and reconfirm.
Please wait a few s
econds after co nfirming the new PIN: SystemLock is being installed.
The following m
essage will be displayed if installation is successful:
Setup Notice
Changes have been saved
[Continue]
► Now press the Enter key. The SystemLock administration menu will be displayed:
Fujitsu 71
To Next Page
Loading...
