Removing and inst alling components
during servicing
Attaching the cover
2
1
► Place the cov
er in its mounting place (1).
► Tighten the screw (2).
► Complete th
e installation, see "
Finishin g component removal", Page 85.
Finishing component removal
After you have removed or changed the system components as required, please
prepare your device for op eration again as follows:
► Install the battery again, see "
Installing a battery", Page 52 .
► Turn th
e notebook the right way up again and place it on a flat surface.
► Reconnect the cables that were previously disconnected.
Fujitsu 85
To Next Page
Loading...
