Appendix
Deactivating/Disconnecting the WLAN Device
Disconnecting the WLAN device may be desired in certain circumstances (to extend battery
life) or where certain environments require it (i.e. hospitals, clinics, airplanes, etc.). The
WLAN device can be disconnected in Windows using th e WLAN icon in the system tray
(Note that disconnecting via the icon in t he s ystem tray does not turn off the radio; it
continues to transmit and receive even though it’s not connected.)
► Press the
button to sta rt the WirelessSelector.
WirelessLANWirelessLANBluetoothBluetooth
The wireless component indicator will go off w hen the wireless compone nts are switched off.
Configuring the Wireless LAN
The opt ional WLAN device can be configured to establish wireless network connectivity
using the software that is built into Windows. Support for most industry s tanda rd
security solutions is contained in this software.
Pre-defined parameters will be required for this proce dure. Please consult with
your network administrator for these parameters:
Configuring the WLAN Using Windows
The WLAN device c
an be configured to establish wireless network connectivity using
the software th
at is built into Windows Vista. Support for most industry standard
security solut
ions is contained in this software.
Pre-defined pa
rameters are required for this procedure. Consult your network
administrato
r for these parameters:
1. F rom the Mode
rn Start screen, press
Windows
+
X
, then select Control Panel from the menu.
2. If the Control Panel is not in Classic View, s elect Classic View from the left panel.
Double-click the Network and Sharing Center icon.
3. Select Setu
p a new connection or network.
4. D epending upon what type of connection you would like to make, m ake a selection. For
an infrastructure network, s e lec t Manually connect to a wireless network.
5. Ente r the
required information. It may be necessary to consult with your network
administ
rator for some of the information.
6. In the event you r equire assistance , go to the Network and Sharing Center window (Control
Panel > Network and Sharing Center), and type in relevant keyword s in the Search box.
Connection to the network
After you have config ured y our computer, you can connect to an active network
by p erforming the following steps:
1. C lick on the WLAN icon in the system tray.
2. Select Connect to a network.
3. Select a network from the list that appears, and click the Connect butto n.
90 Fujitsu
To Next Page
Loading...
