Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. U se the
Tab
key to get to the Application Menu.
3. C heck w hether the Recovery and Utility option is present. If it is not present, it means
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. U se the
Tab
key to get to the Application Menu.
3. C ursor down to Recovery a nd Utility an d press the
Enter
key.
4. C hoose your language, if necessary. Select Recovery and Utility to proceed.
5. T hree t ool option s appe ar: Diagnostics, Recovery,andUtility (refer to the Recovery and
Utility tools section below for instructions on how to use t hese tools).
6. If this was successfu l please skip the next step and go to “Recovery and Utility tools.”
7. If this was NOT su ccessful, please go to the next step .
Running Recovery and U tility from the Bootable disk
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Pow er on your system. When the Fujitsu logo appears on the screen, press the
F12
key.
2. In sert the bootab le disk into the drive tray.
3. H ighlight the C D/DVD option from the Boot menu, then press
Enter
.
4. C lick OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicable, and then press
Enter
.
While the files are being loade d fro m the disk, the Fujitsu logo screen will appear
followed by a progress bar at the bottom of the screen.
96 Fujitsu
To Next Page
Loading...
