Fujitsu MAP3147 - Page 146

Command Specifications
3 -
84
C141-E167
Table 3.5 FORMAT UNIT command defect processing (2 of 3)
CDB Byte 1 Header
FmtData CmpLst Defect list
format
FOV DPRY
Defect
List
Length
Defect Processing Method
1 1
(Note 1,
Note 2)
d d d 1 1 Zero
c Neither the P List or the G List is
used in defect processing
(alternate block allocation
processing is not performed.)
d The P List is saved, but the
previously existing G List is
erased.
1 0
(Note 3)
1 0 0
1 0 1
0
1
0
0
>0
c Alternate block allocation is
performed for defects registered in
the P List, in the previously existing
G List and the defects described in
the D List transferred from the
INIT.
d The D List is added to the
previously existing G List.
1 0 1 0 0
1 0 1
1 1 >0
c Alternate block allocation is
performed for defects registered in
the previously existing G List and
the defects described in the D List
transferred from the INIT.
d The P List is saved, but it is not
used in defect processing.
e The D List is added to the
previously existing G List
1 1 1 0 0
1 0 1
0
1
0
0
>0
c Alternate block allocation is
performed for defects described in
the D List transferred from the
INIT.
d The previously existing G List is
erased and it is not used in defect
processing.
e The D List is registered as the new
G list.
1 1 1 0 0
1 0 1
1 1 >0
c Alternate block allocation is
performed for defects registered in
the P List and the defects described
in the D List transferred from the
INIT.
d The P List is saved, but it is not
used in defect processing.
e The previously existing G List is
erased and it is not used in defect
processing.
f The D List is added to the
previously existing G List.
(Note 1, Note 3)