Fujitsu MAP3147 - Index

C141-E167 IN-1
Index
10-byte CDB basic format 1-2
12-byte CDB basic format 1-2
6-byte CDB basic format 1-1
A
accounting date 4-53
ACE 3-18
active notch 4-32
additional data length 3-5
additional error recovery parameter 4-36,
5-25
additional sense data length 5-3
AGD 3-18
AIP
checking enabled 3-18
generation disabled 3-18
alternate area 1-32
alternate block allocation 6-2
method 6-2
processing 6-2, 6-7
processing by REASSIGN
BLOCKS command 6-3
processing during FORMAT UNIT
command execution 6-2
alternate cylinder 6-2
alternate sector
count/zone 4-15
processing 6-2
alternate track
count/drive 4-15
count/zone 4-15
analysis of termination status 5-12
application client page 4-55
ARRE 4-3
auto alternate block allocation processing
5-23, 6-3
during read operation 5-23
during write operation 5-24
automatic read reallocation enable 4-3
automatic write reallocation enabled 4-3
AWRE 4-3
B
basic disconnect processing procedure 1-13
bit 6 1-4
bit 7 1-4
block descriptor 3-23, 3-32, 6-4
length 3-23, 3-32
buffer data 3-103, 3-108
buffer descriptor 3-109
buffer empty ratio 2-6, 4-11
buffer full ratio 2-5, 4-11
buffer overrun/underrun page 4-39
BUS FREE error 5-13
bus inactivity limit 4-12
BUSY/QUEUE FULL status 5-12
BUSY status 1-7
byte 2 3-23, 3-47
byte 20 4-16
byte distance from index format 3-80
bytes
0 to 2 3-16
10, 11 4-15
12 to 19 4-16
2 to 9 4-15
6 to 16 4-19
C
cache control parameter 2-9
cache segment count 4-26
caching
object command 2-6
operation 2-6
parameter 2-8, 4-21, 6-6
cause 4-39
caution in specifying D list 3-81
CDB
operation code 5-11
size 3-10
specification 6-4
usage data 3-10
changed by another INIT 1-20
CHANGE DEFINITION 3-14
changed operating definition 1-20