Fujitsu PRIMERGY RX1330 M3

RX1330 M3 Operating Manual 61
Starting up and operation
iRMC-related status signals
6
AC
connected
indicator
green on
– The server is switched off and
connected to the mains
(standby mode).
– The server has been switched
on but Power Cycle Delay
settings delay it from turning
on for a specified time.
I After connecting the server
to the mains, it will take
about 60 seconds until the
server will enter standby
mode and can be switched
on.
off
– The server is switched off and
not connected to the mains.
– The server is switched on and
operating normally.
ID indicator
Global error
indicator
Description
blue flashing off
A remote connection has been
established. Local VGA output has been
disabled during the remote session.
blue flashing orange flashing
An emergency flash of the iRMC firmware
is in progress.
I For further information on the
emergency flash of the iRMC
firmware, refer to the "FUJITSU
Server PRIMERGY RX1330 M3
Upgrade and Maintenance
Manual".
Pos. Label Indicator Status Description