Fujitsu PRIMERGY RX1330 M3

RX1330 M3 Operating Manual 75
Starting up and operation
I The software that can be installed depends on your server’s hardware
configuration. This configuration is detected automatically.
I Descriptions of operating systems not covered in the RAID controller
manual are provided in the corresponding readme files under:
http://www.fujitsu.com/global/services/computing/server/ia/driver/index.html
For Japan:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/
To find out how to operate the ServerView Installation Manager and for further
information, refer to the associated manual.
If you are using the ServerView Installation Manager, you can skip the following
section on how to configure the server and install the operating system.
Continue from section "Cleaning the server" on page 76.
6.4.4 Configuring the server and installing the operating
system without the ServerView Installation
Manager
Configuring the onboard SAS/SATA controller
Configure the controller as described in section "Configuring the onboard SATA
controller" on page 73.
Configuring the onboard SAS controller with “Integrated Mirroring
Enhanced”
Configure the controller as described in section "Configuring the onboard SATA
controller" on page 73.
Configure SAS/SATA RAID controller with "MegaRAID functionality"
Configure the controller as described in section "Configuring the SAS/SATA
RAID controller" on page 74.