RX1330 M4 Operating Manual 79
– Wake up On LAN (WOL)
The server is turned on by a command via the LAN (Magic Packet™).
– After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS or in iRMC).
– Power button override
The system can be switched off (hard power off) by keeping the On/Off
button (approximately 4 - 5 seconds).
V CAUTION!
There is a risk that data may be lost.
– iRMC
iRMC offers various options for switching the server on and off, e.g. via the
System power button on the Global icons of the iRMC web interface.
V CAUTION when switching off the power!
The operation of the power switch can be specified as "Do Nothing",
"Stand by", "Hibernate", and "Shutdown" depending on the OS settings.
The default is "Shutdown".
On this server, functions corresponding to "Stand by" and "Hibernate" are
supported as BIOS and hardware functions. However, some drivers and
software installed in the server do not support these functions. For this
reason, functions corresponding to "Stand by" and "Hibernate" are
unavailable on this server. When the operating mode is set to "Stand by"
or "Hibernate", the system may operate improperly or HDD/SSD data
may be corrupted.
For more information about operating mode settings, see the manual
supplied with the OS.
To Next Page
Loading...
Need help?
General
