32 Operating Manual T X100 S2
Important notes
powercfg -h ON
Configuration
To set the driver for the internal LAN controller:
Ê Open the Device Manager via Start - Control Panel - System - Device Manager.
Ê Select Network Adapters.
Ê Select the internal LAN controller: Intel
®
82578DM Gigabit Network
Connection.
Ê Select Properties in the overview, and then select Power Management.
Ê In the Wake on LAN field, enable both of the following options:
– Wake on Magic packet and
– Wake on Magic Packet from power off state.
Ê Press OK.
Execution
To execute the power down command in a DOS shell:
Using the shutdown /h command, your system saves all user data (e.g: open
windows and running programs), shuts down the system, and transfers it to S4
mode.
Exiting the hibernate/idle state (S4 mode)
You switch on the system again either manually using the On/Off button or using
the WOL function (WOL= Wake-up On LAN).
To do this, a Magic Packet with the MAC address of the system to be woken up
is sent to the internal LAN controller.
You will find the valid MAC address for your device under:
Start - Control Panel - System - Device Manager - Network adapters - Intel
®
82578DM
Gigabit Network Connection - Link Speed - Identify Adapter - Permanent Ethernet
Address.
LINUX operating systems
Activation
To Next Page
Loading...
