Fujitsu PRIMERGY TX100 S2 - Setting Up the Server

TX100 S2 Operating Manual 39
Installing the hardware
4.2 Setting up the server
V CAUTION!
Follow the safety instructions in chapter "Important notes" on page 21.
Ê Set up the server.
V CAUTION!
– The device must be protected from direct sunlight.
– Ensure that the minimum clearances (see "Ventilation clearance"
on page 17) are observed.
– Access to the rear of the server must be assured so that other
devices (e.g. memory subsystems) can be connected.
– The mains plug must be accessible easily and safely.
– A clearance of at least 200 mm must be maintained in front of and
behind the system to ensure proper ventilation.
Ê Wire the server. Read the information in section "Connecting devices to the
server" on page 40 and section "Notes on connecting/disconnecting cables"
on page 43.
Ê Connect the system to the mains (see section "Connecting the server to the
mains" on page 42).