TX100 S2 Operating Manual 41
Installing the hardware
The corresponding indicators are explained in section "Rear of server" on
page 47.
I Some of the devices connected require special software (e.g. drivers)
(see documentation for the connected device).
Ê Connect the devices.
Two additional USB ports are located on the front of the server (see figure 4 on
page 45).
I If components with large power requirements (e.g. external USB hard
disk drives) are connected simultaneously, these USB connectors may
be switched off.
Connecting the keyboard, mouse and monitor
Ê Connect the monitor, the keyboard and the mouse to the standard ports of
the server (see figure 2 on page 40).
Ê Connect the power cable of the monitor to a grounded power outlet of the in-
house mains and/or to the mains socket strip of the rack.
V CAUTION!
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
To Next Page
Loading...
