40 Operating Manual TX1320 M3
● The circuit boards and soldered parts of internal options are exposed and
can be damaged by static electricity. To ensure reliable protection, you must
wear an earthing band on your wrist when working with ESD modules and
connect it to an unpainted, conducting metal part of the server.
● Any devices or tools that are used must be free of electrostatic charge.
● Wear a suitable grounding cable that connects you to the external chassis
of the server.
● Always hold ESD modules at the edges or at the points marked green (touch
points).
● Do not touch any connectors or conduction paths on an ESD module.
● Place all the components on a pad which is free of electrostatic charge.
I For a detailed description of how to handle ESD modules, see the
relevant European or international standards (EN 61340-5-1,
ANSI/ESD S20.20).
Transporting the server
V CAUTION!
Only transport the server in its original packaging or in packaging that
protects it from impacts and jolts.
In Japan and APAC, transporting the server in its original packaging does
not apply.
Do not unpack the server until it is at its installation location.
If you need to lift or transport the server, ask other people to help you.
Never lift or carry the server by the handles or the Quick Release Levers
(QRLs) on the front panel.
Notes on installing the server in the rack
V CAUTION!
● For safety reasons, at least 2 people are required to install the server
in the rack because of its weight and size.
(For the reader in Japan, please refer to " 安全上のご注意 ".)
● Never lift the server into the rack using the QRLs (Quick Release
Levers) on the front panel.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
