Fujitsu PRIMERGY TX1330 M3 - Page 15

TX1330 M3 Operating Manual 15
Functional overview
HDDs
The server is shipped with one of the following drive cages:
– For up to twelve 3.5-inch SAS/SATA HDDs:
Up to twelve 3.5-inch SAS/SATA HDD modules can be used in the drive
cage. Each HDD module can accommodate an SAS/SATA HDD with a
maximum height of 1 inch. The HDD modules are connected to the
SAS/SATA backplane wirelessly. This allows HDD modules to be plugged in
or pulled out easily.
I Up to four SATA HDDs are controlled by the onboard SATA controller.
An additional SAS/SATA RAIDcontroller must be installed to control
additional SATA HDDs or SAS HDDs.
I Configurations with Eco SATA can only be mixed with BC SATA HDD
type. SAS and BC SATA drives with the same size can be mixed, but
not used in the same logical RAID volume.
– For up to twenty four 2.5-inch SAS/SATA HDDs or 2.5-inch SATA SSD
drives:
Up to twenty four 2.5-inch HDD/SSD modules can be used in the drive cage.
Each module can accommodate SAS/SATA HDD or an SATA SSD drive with
a 2.5-inch format. The HDD/SSD modules are connected to the SAS/SATA
backplane wirelessly. This allows modules to be plugged in or pulled out
easily.
I Up to eight SAS/SATA HDDs are controlled by the SAS/SATA RAID
controller already installed.
I Configurations with Eco SATA can only be mixed with BC SATA HDD
type. SAS and BC SATA drives with the same size can be mixed, but
not used in the same logical RAID volume.
Hybrid configurations of SATA HDD and SATA SSD modules are supported.
If the server has the corresponding RAID configuration, the HDD modules can
also be replaced during operation.