EasyManuals Logo
Home>Fujitsu>Server>PRIMERGY TX1330 M3

Fujitsu PRIMERGY TX1330 M3 User Manual

Fujitsu PRIMERGY TX1330 M3
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
TX1330 M3
Operating Manual 35
Important information
The adequately shielded data cables must be used.
All data and signal cables must have sufficient shielding. The use of cable
type S/FTP Cat5 or higher is recommended.
Use of unshielded or badly shielded cables may lead to increased emission
of interference and/or reduced fault-tolerance of the device.
Ethernet cabling has to comply with EN 50173 and EN 50174-1/2 standards
or ISO/IEC 11801 standard respectively. The minimum requirement is a
Category 5 shielded cable for 10/100 Ethernet, or a Category 5e cable for
Gigabit Ethernet.
Route the cables in such a way that they do not create a potential hazard
(make sure no-one can trip over them) and that they cannot be damaged.
When connecting the server, refer to the relevant instructions in this manual.
Never connect or disconnect data transmission lines during a storm (risk of
lightning hazard).
Make sure that no objects (e.g. jewelry, paperclips etc.) or liquids can get
inside the server (risk of electric shock, short circuit).
In emergencies (e.g. damaged casing, controls or cables, penetration of
liquids or foreign bodies), contact the server administrator or your customer
service team. Only disconnect the server from the mains power supply if
there is no risk of harming yourself.
Proper operation of the server (in accordance with IEC 60950-1 resp.
EN 60950-1) is only ensured if the server is completely assembled and the
rear covers for the installation slots have been fitted (electric shock, cooling,
fire protection, interference suppression).
Only install server expansions that satisfy the requirements and rules
governing safety and electromagnetic compatibility and those relating to
telecommunication terminals. If you install other expansions, they may
damage the server or violate the safety regulations. Information on which
server expansions are approved for installation can be obtained from our
customer service center or your sales outlet.
The components marked with a warning notice (e.g. lightning symbol) may
only be opened, removed or exchanged by authorized, qualified personnel.
Exception: CSS components can be replaced.
The warranty is void if the server is damaged during installation or
replacement of server expansions.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX1330 M3 and is the answer not in the manual?

Fujitsu PRIMERGY TX1330 M3 Specifications

General IconGeneral
Processor socket-
Built-in processorNo
Motherboard chipsetIntel® C236
Compatible processor seriesIntel Core i3, Intel Pentium Dual-Core, Intel Xeon
Number of processors supported1
ECCYes
Number of DIMM slots4
Supported memory typesDDR4-SDRAM
Maximum internal memory64 GB
Storage drive sizes supported2.5, 3.5 \
Supported storage drive typesHDD & SSD
Number of storage drives supported24
Supported storage drive interfacesSerial ATA, Serial Attached SCSI (SAS)
LAN controllerIntel I210
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet interface typeGigabit Ethernet
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports2
PCI Express slots version3.0
Chassis typeRack (4U)
Product colorBlack, Red

Related product manuals