Fujitsu PRIMERGY TX150 S6 Notes On Using

Chapter 6 "6.2 Removing and Attaching Covers"
6.2.1 Removing Covers
■Attaching covers (Page 116)
Addition Following caution notes are added for attaching the cover description.
Before attaching the covers, flip the front cover and make sure the position of the key lock part (Point A) is
settled at the
proper position . If the key lock part is not at the proper position , resetting the part before
attaching the covers are required. It may cause a breakage failure if you attach the covers and lock the key
with wrong position.
back side the front covers
All Rights Reserved, Copyright© FUJITSU LIMITED 2008
3／8
Close-up of point A
Point Ａ
Improper Position
Key lock part is unhooked (yellow circle).
Proper Position
Key lock part is hooked.

Fujitsu PRIMERGY TX150 S6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX150 S6
Category	Server
Language	English