TX2560 M2 / RX2560 M2
Operating Manual 43
Information for ensuring electromagnetic compatibility
All data and signal cables must have sufficient shielding. The use of cable type
S/FTP Cat5 or higher is recommended.
Use of unshielded or badly shielded cables may lead to increased emission of
interference and/or reduced fault-tolerance of the device.
Other important information:
●
During cleaning, observe the instructions in section "Cleaning the server" on
page 79.
●
Keep this operating manual and the other documentation close to the
device. All documentation must be included if the equipment is passed on to
a third party.
4.2 CE conformity
The system complies with the following requirements of the
EC directives:
2014/30/EU "Electromagnetic Compatibility"
2014/35/EU "Low Voltage Directive"
2009/125/EC "Ecodesign Directive"
2011/65/EC. "Restriction of hazardous substances"
This is indicated by the CE marking (CE = Communauté
Européenne).
V CAUTION!
This is a Class A product. In a domestic environment this
product may cause RF interference, in which case the
user may be required to take adequate measures.
To Next Page
Loading...
