88 Operating Manual
TX2560 M2 / RX2560 M2
8.10 Added drive reported as defective
RAID controller is not configured for this drive
The drive was probably installed when the system was switched off.
Ê Reconfigure the RAID controller for the drive using the corresponding utility.
Information is provided in the documentation for the RAID controller.
or
Ê Remove and reinstall the drive while the system is switched ON.
If the hard disk drive continues to be shown as defective, then replace it (see
the "FUJITSU Server PRIMERGY TX2560 M2 / RX2560 M2 Server Upgrade
and Maintenance Manual").
I Further information is provided in the "Integrated RAID for SAS User’s
Guide" (on the Fujitsu manuals server under x86 Servers - Expansion Cards
- Storage Adapters - LSI RAID / SCSI Controllers) or in the "Modular RAID
Controller Installation Guide" (on the Fujitsu manuals server under
x86 Servers - Expansion Cards - Storage Adapters - LSI RAID / SCSI
Controllers).
For more information on configuring the controller, see section
"Configuring the server" on page 75.
8.11 Error message on screen
The meaning of the error message is explained in the documentation for the
relevant components and programs on the Fujitsu manuals server.
8.12 Expansion cards or onboard devices not
recognized
When an expansion card is added, other expansion cards or onboard devices
might not be recognized.
Ê Reinstall the drivers for the expansion cards or onboard devices that are not
recognized.
To Next Page
Loading...
