TX2560 M2 / RX2560 M2
Operating Manual 73
Starting up and operation
– Starting up for the first time:
For the Japanese market, please refer to " はじめにお読みください ".
Ê Press the On/Off button.
Ê Insert ServerView Suite Installation DVD 1 in the DVD drive.
Ê Follow the on-screen instructions (see also section "Configuring the
server and installing the operating system with the ServerView
Installation Manager" on page 77 or section "Configuring the server and
installing the operating system without the ServerView Installation
Manager" on page 78).
– System already installed:
Ê Press the On/Off button.
The server is switched on, performs a system test and boots the
operating system.
I In the case of configurations with a large memory size, the boot
process may be prolonged and the screen may remain dark for
several minutes.
Switching the server off
The Power-on indicator (see figure 7 on page 61) lights up green.
Ê Shut down the operating system properly.
The server is switched off automatically and enters standby mode. The power-
on indicator lights up green.
I If the operating system does not switch off the server automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal for power button override.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S4, you can configure
that the server is switched on/off controlled by an internal timer.
To Next Page
Loading...
