Fujitsu PRIMERGY TX300 S7 - Connecting Devices to the Server

54 Operating Manual TX300 S7 / RX350 S7
Hardware installation
5.4 Connecting devices to the server
The connectors for external devices are on the front and rear of the server. The
additional connectors available on your server depend on the expansion cards
installed. For further information refer to the "PRIMERGY TX300 S7⁄ RX350 S7
Server Upgrade and Maintenance Manual".
Figure 2: Connection panel on the rear
The corresponding indicators are explained in section "Rear of server" on
page 71.
I Some of the devices connected require special software (e.g. drivers)
(see documentation for the connected device).
Ê Connect the devices.
1 Video connector (blue) 4 Shared LAN connector (LAN 1)
2 Management LAN connector 5 Serial connector COM1*
(turquoise)
3 Standard LAN connector (LAN 2) 6 4 USB connectors (black)
* The serial interface COM1 can be used as the standard interface or for
communication with iRMC S3.