Fujitsu ScanSnap fi-5110EOXM

3.5 Various settings according to your needs
ScanSnap fi-5110EOXM Operator's Guide 51
Basic Scanner Operations
3
■ Scanning only one side of a document
As the default setting, pressing [SCAN] button on ScanSnap starts scanning documents in
"Duplex" mode. If most of your documents are single side you can change the default scan to
"Simplex" by following the procedure below.
Operation
1. Click and hold the ScanSnap icon , and select "Setting" from the menu.
2. Click the [Scanning] tab and select [Simplex scan] at [SCAN button:].
3. Click [OK] button to close the window.
4. Load the document onto the scanner.
5. Press the [SCAN] button .
SCAN
SCAN