ETERNUS LT40 S2 tape library Periphery
52 U41861-J-Z126-1-76
Ê Enable the Random option in Library Mode.
Ê Enable the mailslot.
Ê Enable auto cleaning.
Ê Click Refresh to activate the changes.
i When two drives are operating in Sequential Mode, you are recommended not to
enable the Autoload and Loop options, see the note on page 54.
To guarantee BS2000 operation, you may not change the following configuration settings:
Configuration > System (SAS variant):
Mailslot(s) --> active
Auto Clean --> active
Barcode Label Length ... --> 8
Barcode Label Alignment ... --> Left
Configuration > Drive (FC variant):
Recommendation --> Fixed topology / Speed setting
To Next Page
Loading...
Need help?
General