Fujitsu SOFTUNE - Debug Functions; Switching Debug Function; Switching Methods

159
CHAPTER2 Dependence Functions
2.4.3.2 Switching Debug Function
This section describes the method of switching the debug function correspondingly to
the usage.
■ Debug Functions
Some of the debugging features are exclusive features which cannot be set simultaneously. Exclusive
features require to switch modes depending on usage.
The mode has two types described below.
• Execution time mode
This mode selects the method of measuring the user-program execution time.
- Time measurement mode (default)
Measures the time from the execution start to break.
- Performance mode
Measures the transit time between two points of set event.
• Pass count mode
This mode selects the using method for the pass count function.
- Sequential mode
This mode uses the sequencer function.
The pass count break cannot be used.
- Pass count break mode (default)
This mode uses the hardware/count break.
The sequencer function cannot be used.
■ Switching methods
Methods of switching to the execution time mode and the pass count mode are described below.
● Dialog
- [Event] tab in debug environment dialog
For details, refer to "4.7.2.3 Debug Environment" in "SOFTUNE Workbench Operation Manual".
● Command
- SET MODE
For details, refer to "1.7 SET MODE (type 2)" in "SOFTUNE Workbench Command Reference
Manual".