Fujitsu SOFTUNE - Trace Trigger Break

176
CHAPTER2 Dependence Functions
2.4.6.4 Trace Trigger Break
This function suspends program execution when a trace trigger terminates trace
acquisition.
■ Trace Trigger Break
This function suspends program execution when a trace trigger terminates trace acquisition. Only one point
can be set.
When the trace trigger break occurs, the following message appears in the status bar.
Break at address by trace end break
■ How to set
Control the trace trigger break in the following methods:
• Dialog
- Trace setting dialog
For details, refer to "4.4.8 Trace" in "SOFTUNE Workbench Operation Manual".
• Command
- SET TRACE/BREAK
For details, refer to "4.12 SET TRACE (type 2)" in "SOFTUNE Workbench Command Reference
Manual".
Note:
A trace trigger break shares points with the following functions. The maximum number of trace
trigger breaks varies depending on how those functions are used.
• Code break
• Data break
• Data watch break
• Sequencer