Fujitsu SOFTUNE - Code Break (Hardware)

171
CHAPTER2 Dependence Functions
2.4.6.1 Code Break (Hardware)
This function suspends program execution by monitoring a specified address by
hardware.
■ Code Break (Hardware)
This function suspends program execution by monitoring a specified address by hardware. A break occurs
before an instruction at the specified address is executed.
Code Break (Hardware) has the hardware/count for which a path count can be set.
The maximum number of points that can be set is as follows:
Hardware: 8 points
Hardware/count: 2 points
When the code break (hardware) occurs, the following message appears in the status bar.
• Hardware:
Break at address by code event break
• Hardware/count
Break at address by sequential or pass count break
■ How to set
Control the code break in the following methods:
• Dialog
- "Code" tab in the breakpoint setting dialog
For details, refer to "4.6.4 Breakpoints" in "SOFTUNE Workbench Operation Manual".
•Window
- Source window/disassemble window
For details, refer to "3.7 Source Window" or "3.9 Disassemble Window" in "SOFTUNE Workbench
Operation Manual".
• Command
- SET BREAK/HARD
For details, refer to "3.1 SET BREAK(type 1)" in "SOFTUNE Workbench Command Reference
Manual".