172
CHAPTER2 Dependence Functions
Notes:
• Do not set the code break to an instruction placed in a delay slot. If a code break is set and the
branch instruction is executed, the following phenomenon occurs.
Hardware: A break set in the delay slot does not occur.
• When setting a breakpoint, always specify the starting address of the instruction. A break may not
occur if an address other than the starting address is specified.
• A code break shares points with the following functions. The maximum number of code breaks
varies depending on how those functions are used.
- Data break
- Data watch break
- Trace trigger
- Sequencer
• When hardware or hardware/count break is set at the top of the reset handler, the break does not
occur.
• When the pass count mode is the passing count break mode, the hardware/count break cannot
be used. For details, refer to "2.4.3.2 Switching Debug Function".
To Next Page
Loading...