Fujitsu SOFTUNE - Trace Buffer-Full Break

46
CHAPTER2 Dependence Functions
2.1.8.3 Trace Buffer-full Break
This function aborts the program execution when the trace buffer becomes full.
■ Trace Buffer-full Break
This function aborts the program execution when the trace buffer becomes full.
When the trace buffer-full break occurs, the following message appears at the status bar.
Break at address by trace buffer full
■ How to set
Set the trace buffer-full break as follows.
• Command
- SET TRACE/BREAK
For details, refer to "4.12 SET TRACE(type 2)" in "SOFTUNE Workbench Command Reference
Manual".
• Dialog
- Trace setting dialog
For details, refer to "4.4.8 Trace" in "SOFTUNE Workbench Operation Manual".