40
CHAPTER2 Dependence Functions
2.1.5 Reset Simulation
This section describes the reset simulation executed.
■ Reset Simulation
The simulator simulates the operation when a reset signal is input to the MCU using the [Debug]-[Reset
MCU] menu or RESET command, and initializes the registers.
The function for performing reset processing by operation of MCU instructions (writing to RST bit in
standby control register) is also supported.
The register with the RST bit is different according to the FR/FR80 as follows.
FR :Standby mode Control Register
FR80 :Reset Control Register
To Next Page
Loading...