Fujitsu SOFTUNE - Executing Program; Control During Program Execution; Executing a Program

160
CHAPTER2 Dependence Functions
2.4.4 Executing Program
This section describes the method of executing a user program.
■ Executing a program
A user program is executed in a procedure described below.
1. Open a project (workspace).
Select the [File] - [Open workspace file] menu.
2. Start debugging.
Refer to "2.4.1 Starting debugging".
3. Load an execution-desired target program.
When loading a project target file, select the [Debug] - [Load target file] menu.
4. Execute program.
Select the [Debug] - [Run] - [GO] menu.
For other executions, such as step execution, refer to "4.6.1 Run" in "SOFTUNE Workbench Operation
Manual".
■ Control during program execution
The emulator debugger (MB2100-01) is capable of controlling the following during the execution of a user
program.
• Debug function setting/release
• Monitoring
• Power-on debug