162
CHAPTER2 Dependence Functions
*1 : Refer to "SOFTUNE Workbench Command Reference Manual".
Note:
An error message appears if you enter a command that cannot be used during the execution of
auser program.
"E4404S Command error (MCU is busy)."
Trace operation 4.15 SET TRACE (type2)
4.18 CLEAR TRACE
4.20 ENABLE TRACE (type2)
4.22 DISABLE TRACE (type2)
4.23 SEARCH TRACE
4.24 SET DATATRACEAREA
4.26 CANCEL DATATRACEAREA
4.33 SET DELAY
Table 2.4-1 Commands Available during Execution of User Program (2 / 2)
Function Major Command name
*1
To Next Page
Loading...