1-11-2 E434AFIS
< DVD/HDD Section >
Note: If an error occurs, a message with the error number appears on the screen.
Message Error No. Error Description Error Example
Disc error
04-50
Renewal error at
ejecting disc
This code is output when there is a control information writing failure
due to tray being open during writing or disc loading.
04-51
Disc includes still
picture
This code is output upon attempt to write data (finalizing disc protect
data, etc.) on a disc including a still picture.
Recording
error
03-50
Recording error
caused by media
error
This code is output when recording error caused by media error
occurs, e.g.,stopping recording during attempting to record on a
scratched disc.
03-52 Loader error
This code is output when tray open/close error occurs. Also, when
the tray open error occurs at F/E and when the recovery fails even if
the B/E retries.
03-53 Poor media
This code is output when a DVD operation error occurs during
copying.
03-54
Control information
error and control data
error
This code is output when a chip (EMMA) outputs unusual data while
recording and the control information writing fails.
03-55 Writing error (video)
This code is output when video writing fails while copying at high
speed.
03-56 General error
This code is output when a number of errors occur:
Ex.1) When Outplay list creation fails.
Ex.2) When the system can’t take the title information which should
be written on the disc.
Ex3) When starting to copy, recording is paused and restarted but,
after the recording pause, recording start fails.
03-57 Device error
This code is output when an HDD operation error occurs (HDD
recording error), while copying at high speed or constant speed.
03-60 Unrecordable disc
This code is output when recording is attempted on a non -
recordable disc such as a CD or DVD-ROM.
System error
02-50
Erasing error (all
titles)
This code is output when an error occurs erasing entire VR playlist,
HDD playlist or HDD originals.
02-51 Disc protection failure
This code is output when protected pre-existing information that
should be on a disc is missing (VR disc protection error).
02-52 Format failure
This code is output when HDD formatting occurs in maintenance
mode.
02-53 Abnormal loader This code is output when an appropriate DVD drive is not connected.
02-54
Abnormal HDD
mount
This code is output when a [PLAY], [STOP], [REC], [MENU] or [LIST]
button is pressed while HDD is not functional.
02-55
Changing status
failure during VCR
dubbing
This code is output when, during dubbing from HDD or DVD to VCR,
playback cannot be initiated or playback cannot be discontinued.
02-56
Abnormal VCR
mechanism
This code is output when a VCR mechanism abnormality occurs.
After the error message is displayed, the power turns off.
02-57 Fan lock
This code is output when fan locking (over 30 seconds) is detected.
After the error message is displayed, the power turns off.
02-58 F/E hang-up
This code is output when an F/E hang-up event occurs. After the
error message is displayed, the power turns off.
02-59 HDD hang-up
This code is output when HDD hang-up event occurs. After the error
message is displayed, the power turns off.
Recording Error
03-50
Error No.
Error message
To Next Page
Loading...
