Why is the picture on my FUNAI LCD TV so weak?
If the picture on your FUNAI LCD TV appears weak, try moving the TV away from other appliances that emit strong magnetic fields. If this doesn't work, turn the TV off using the STANDBY-ON button, and then turn it back on after about 30 minutes.
What to do if the picture rolls vertically on my FUNAI LCD TV?
If the picture on your FUNAI LCD TV rolls vertically, turn the TV off with the STANDBY-ON button, and then turn it on again after about a minute.
How to remove lines or streaks in the picture on my FUNAI LCD TV?
If you see lines or streaks in the picture on your FUNAI LCD TV, turn the TV off with the STANDBY-ON button, and then turn it on again after about a minute.
What causes different color marks on the screen of my FUNAI LCD TV?
The different color marks on the screen of your FUNAI LCD TV are a quality of the LCD Panel.
What does a black or luminous point on the screen of my FUNAI LCD TV mean?
The black or luminous point on the screen of your FUNAI LCD TV indicates that the life of the Back Light is approximately 50,000 hours. Ask the Service Centre to replace it.
General| Display Technology | LCD |
|---|---|
| Resolution | 1366 x 768 |
| Aspect Ratio | 16:9 |
| Component Video Input | 1 |
| Composite Video Input | 1 |
| VGA Input | 1 |
| RF Antenna Input | 1 |
| Refresh Rate | 60 Hz |
| Screen Size | 32 inches |
| Inputs | HDMI, Component, Composite, VGA, RF |
| Weight | 15.4 lbs |
| Sound Output | 10W (5W x 2) |
Critical safety checks before returning the TV to the customer.
Warnings about hot chassis, lead dress, and design alterations.
Use of specified parts, wiring, and insulation for safety during servicing.
Guidelines for handling components and assembling cabinet parts.
Verifying clearance distance and measuring leakage current after repair.
Procedures for removing and installing flat pack ICs.
Grounding procedures for human body and workbench.
Steps to enter service mode and reset the LCD television.
Setting initial data values for various TV modes.
Procedures for checking panel purity and adjusting flicker.
Mixing red, green, and blue beams for pure white output.
Shows the circuit responsible for the LCD backlight.
List of all electrical components with their part numbers.
To Next Page
