To Next Page

To Previous Page

means that it is fully compatible with all phones supporting the Bluetooth

hands-free proﬁ le. If you are uncertain, read

the operating instructions for your mobile phone to see which proﬁ les are supported.

A2DP (Advanced Audio Distribution Proﬁ le) is a technology that enables the wireless transmission of stereo audio

signals via Bluetooth

to a compatible receiving device. Please take a look at our homepage for information about

compatible mobile phones.

7.4.2 On / Off function

The ﬁ rst time you use your EGO FLASH, you must start the EGO FLASH by turning the ignition key. You will see the

starting logo and the main display screen. If no connection to a mobile phone exists or no user is found, the functionality

of the main menu is restricted.

In order to connect to the EGO FLASH, you must select the “User management” menu item with . “New user” is

then selected. The EGO FLASH will then search for mobile phones within its range of reception. If it fails to ﬁ nd your

mobile phone, you may repeat the search, or read the section on “Troubleshooting”. When the name of your mobile

phone is shown, select it with the key. After a connection is established with the EGO FLASH, the main menu

is fully functional. Functionalities that are not supported by the mobile phone are not selectable. If the ignition is

switched off, the EGO FLASH shuts itself off. If the ignition is switched off during a phone call, the call continues without

interruption. The EGO FLASH will shut itself off only after the phone call is ended.

7.4.3 Enter Bluetooth

After a few seconds you will be prompted to enter your Bluetooth

PIN. Enter the PIN shown on the EGO FLASH display

onto your mobile phone.

7.4.4 Hands-free mode

In some cases, coupling with your mobile phone in the hands-free mode does not work when using the method described

above. If you are sure that your mobile phone supports the Bluetooth

hands-free proﬁ le, proceed as follows: In the list

of detected devices, select “couple from phone”. Now you need to search for Bluetooth

devices using your mobile phone.

The procedure for this can be found in the operating instructions for your mobile phone. The mobile phone will then start

searching for devices. Select the EGO FLASH from the list of devices found by your mobile phone. During the coupling

Funkwerk EGO FLASH User Manual

Other manuals for Funkwerk EGO FLASH