Reset user
To delete all user information, open user management. Select the user you want to reset. Confi rm your selection by
pressing the key. A menu then opens. Select “Delete” in this menu. All data for this user is now deleted from the
EGO FLASH.
Switch user
To switch users, go to “User management” and select the desired user. Confi rm your selection by pressing the key.
A submenu then opens. Select “Log in” in this menu. If the selected user can be found, the users are switched
immediately. If the user cannot be found, the menu jumps back to “User management”.
Log out user
You can disconnect the current Bluetooth
®
connection within “User management” under the current user with the “Log
out” menu item.
7.5.2 Call
If there is an existing Bluetooth
®
connection between the EGO FLASH and a mobile phone, you can use the hands-free
function of the EGO FLASH. If there is no connection, you cannot use the hands-free function. You must fi rst establish a
Bluetooth
®
connection. You may dial a number with voice-activated dialing, through the menu or directly on the mobile
phone.
Incoming call
If the mobile phone is available over the Bluetooth
®
connection, the call is signaled with the ringtone on your mobile
phone. Otherwise a signaling tone is generated by the EGO FLASH.
If the caller has not blocked display of his phone number, and if the mobile phone supports this function, the display of
the control unit will show the caller’s number or, if a corresponding entry is found in the contacts list, the caller’s name.
You can decide whether to take the call (green key or key) or reject it (red key or key). If you accept
the call, you can adjust the volume with the , keys. The settings are saved. You can end the call by pressing
the key.
EGO FLASH
To Next Page
Loading...
Need help?
General
