To Next Page

To Previous Page

A2DP (Advanced Audio Distribution Proﬁ le) is a technology that enables the wireless transmission of stereo audio

signals via Bluetooth

to a compatible receiving device. Please take a look at our homepage for information about

compatible mobile phones.

7.3.2 On / Off function

Turning the ignition key simultaneously activates the hands-free system. Immediately after the system is activated, the

two LEDs blink four times. This indicates that the system is in standby mode and ready to make a connection. In order

to use the system for phone calls, a Bluetooth

compatible phone must be coupled to the EGO TALK system. How this

is done is explained in detail in the following sections. When the ignition is turned off, the hands-free system also shuts

down. If the ignition is turned off during a call, the phone’s capabilities are maintained and the system only shuts down

when the call has been completed.

7.3.3 Coupling

A mobile phone intended for use with the hands-free system must be coupled to the EGO TALK. As long as no devices

are connected, the system is visible for all Bluetooth

devices. In this state, the green LED blinks every 7.5 seconds to

indicate that no devices are connected. The telephone to be used must be registered with the EGO TALK. The Bluetooth

search and coupling procedure is initiated from the telephone. Die Bluetooth

code is “EGO TALK”. The default input

PIN is “0000”. When the connection/coupling procedure is successfully completed, both diodes are steadily on. One

phone per user may be coupled. If you wish to couple an additional phone, use your initial phone to decouple the current

connection. Should you encounter problems while coupling, please read the section “Solving Problems”, and take a look

in your phone manual at the section about Bluetooth

operations.

7.3.4 Automatic coupling

If a phone is already connected with the system, the EGO TALK tries to couple to this phone. When a connection has

been successfully made, the two LEDs are steadily on. The connection is always made to the most recently coupled

phone. If this phone is out of range, the system will search for other phones registered in the system. When the search is

successful, the connection to this phone is completed automatically. If the search process was unsuccessful, the system

reverts to the coupling mode. This enables manual connection from the phone.

Funkwerk EGO TALK User Manual

Other manuals for Funkwerk EGO TALK