1. OPERATIONAL OVERVIEW
1-12
1.6.2 Selecting a display
1. Press the [DISP] key to show the full-screen selection window. The icons of
modes not available are marked with “X” mark. PAGE1-PAGE5 are
user-arrangeable displays called “hot pages,” which you can configure as you
like. For further details, see “5.5 Hot Page Setup.”
PAGE1 PAGE2 PAGE3 PAGE4 PAGE5
RADAR PLOT SNDR NAV OVRLY
· TURN KNOB TO SELECT MODE
AND PUSH KNOB TO ENTER.
· PUSH ANY SOFT KEY TO
SELECT IMAGE SOURCE.
Basic display
screens
Hot pages
Full-screen selection window (“overlay” for color model)
2. Rotate the [ENTER] knob to select a basic display screen or a hot page
screen.
3. Push the [ENTER] knob. If you selected a basic display screen, a set of
combination display screens corresponding to the basic display screen that
was selected appear. In the example below, radar combination displays are
shown.
PUSH ENTER KNOB.
Radar combination screen selection window
4. Operate the [ENTER] knob to select the combination screen display desired
and push it to set.
To Next Page
Loading...
