3. ADVANCED SONAR OPERATION
3-14
3. To turn off the stabilizer, press the [STABILIZER] key. The stabilizer mark,
stabilizer indication and stabilizer bearing data are erased. If range and
bearing marks are shown they are displayed along with their data.
Note 1: The tilt angle can be manually set in the range of 0-55°, however
pitching and rolling are compensated within the ±20° in the tilt angle
range of 0 to 55°.
Note 2: If the target lock is activated while the stabilizer is on, the bearing set for
target lock will be used with the stabilizer as well and the stabilizer mark
is erased. When the target lock is turned off, the bearing set before
target lock was turned on is used and the stabilizer mark reappears at
the bearing originally selected.
To Next Page
Loading...
Need help?
General
