Furuno FE-800 - Page 17

2. WIRING
12
DTI-C5E350 VCV
Note: Do not use an optical fiber cable.
How to fabricate the LAN connector
Armor
Outer vinyl
sheath
Outer vinyl
sheath
Inner vinyl sheathInner vinyl sheath
more than 50
Vinyl tapeVinyl tape
Modular plugModular plug
Clamp here.Clamp here.
20
280
Cable jacketCable jacket
Using the special crimping
tool MPT5-8 (PANDUIT CORP.),
crimp the modular plug.
Finally, check the plug visually.
Expose inner vinyl sheath.
1 WHT/GRN
2 GRN
3 WHT/ORG
4 BLU
5 WHT/BLE
6 ORG
7 WHT/BRN
8 BRN
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLE 5
GRN 6
WHT/BRN 7
BRN 8
[Cross-over cable]
1 WHT/ORG
2 ORG
3 WHT/GRN
4 BLU
5 WHT/BLE
6 GRN
7 WHT/BRN
8 BRN
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLE 5
GRN 6
WHT/BRN 7
BRN 8
[Straight cable]
Remove the outer sheath by
approx 25 mm. Be careful
not to damage inner shield
and cores.
Fold back the shield, wrap it
onto the outer sheath and
cut it, leaving 9 mm.
12
3
25 mm
approx. 9 mm
4
5
6
approx. 9 mm
approx. 11 mm
Drain wire
Fold back drain wire and
cut it, leaving 9 mm.
Straighten and flatten the
core in order and cut them,
leaving 11 mm.
Insert the cable into the
modular
plug so that the folded part of
the shield enters the modular
plug. The drain wire must be
on the tab side of the jack.
7
1
8
Modular plug