1
1. MOUNTING
1.1 Display Unit
1.1.1 Installation consideration
The display unit can be installed on a desktop or flush mounted in a console or panel.
When selecting a mounting location, keep in mind the following points:
• The nominal viewing distance for the display unit is 0.9 m. Select a suitable mount-
ing location considering that distance.
• Locate the unit away from exhaust pipes and vents.
• Select an installation location that is well ventilated.
• Locate the unit where shock and vibration are minimal.
• Locate the unit away from equipment which generates the electromagnetic fields
like a motor or generator.
• Allow enough maintenance space at the sides and rear of the unit and leave enough
slack in cables to facilitate maintenance and servicing.
• Observe the compass safe distances in the "SAFETY INSTRUCTIONS" (on page i)
to prevent interference to a magnetic compass.
• For flush mounting in a panel, the mounting surface must be flat. Do not install the
unit on an uneven surface.
1.1.2 How to remove the cover
While pressing the center of the cover with
your thumbs as shown in the right figure, pull
the cover towards you to remove it.
NOTICE
Do not apply paint, anti-corrosive sealant or
contact spray to coating or plastic parts of the
equipment.
Those items contain organic solvents that can
damage coating and plastic parts, especially plastic
connectors.
To Next Page
Loading...
