Furuno FE-800 - FOREWORD; A Word to FE-800 Owners; Features of the FE-800

1. MOUNTING
2
1.1.3 Flush mounting
For details, see the outline diagrams at the back of this manual.
For octagonal cutout
1. Make an octagonal cutout in the mounting location as shown in the illustration be-
low.
2. Make four pilot holes for self-tapping screws in the location indicated in the illus-
tration below.
3. Set the display unit to the cutout and fasten the display unit with four self-tapping
screws (φ5×20).
4. Set a cosmetic cap to each fixing hole on the front panel. (See "How to set the
cosmetic cap" on page 4.)
For square cutout
You can install the display unit in a square cutout using with the optional kit OP26-28.
Front Fixing Panel OP26-28 (code no.: 001-247-250)
1. Make a square cutout (239±1 mm) in the mounting location referring to the outline
drawing at the back of the manual.
2. Make four pilot holes for self-tapping screws in the location.
3. Attach the front fixing panel to the display unit from the front side with binding
screws (M5×16).
4. Set the display unit to the cutout and fasten the display unit with four self-tapping
screws (φ5×20) from the front side.
5. Set a cosmetic cap to each fixing hole on the front panel. (See "How to set the
cosmetic cap" on page 4.)
No. Name Type Code no. Qty Remarks
1 Self-tapping screw 5×20 SUS304 000-163-915-10 4
2 Front fixing panel 26-003-1701 100-382-080-10 1
3 Binding screw M5×16 SUSU304 000-163-898-10 4
4 Manual C72-01302-* —
78 (3.07
"
)
12 (0.47
"
)
240 (9.45
"
)
240 (9.45
"
)
Fixing hole (4-ø6)
223±0.5 (8.78")
223 ± 0.5 (8.78")
18 (0.71")
18 (0.71")
Pilot hole (4 places)
Cutout
18 (0.71")